Double VLAN Tunneling Help

Help for Double VLAN Tunneling Configuration

Selection Criteria

• Slot/Port - Select the physical interface for which you want to display or configure data. Select 'All' to set the parameters for all ports to same values.

Configurable Data

• Mode - This specifies the administrative mode via which Double VLAN Tagging can be enabled or disabled. The default value for this is Disabled.
• Customer ID - This is a 12 bit customer ID which will be used as the last 12 bits of the DVlan tag. The valid range for a customer Id is (0 to 4095). The default customer Id is 0 .
• EtherType - The two-byte hex EtherType to be used as the first 16 bits of the DVlan tag.
  • 802.1Q Tag - Commonly used tag representing 0x8100
  • vMAN Tag - Commonly used tag representing 0x88A8
  • Custom Tag - Configure the EtherType in any range from (0 to 65535)

Command Buttons

• Submit - Update the switch with the values on this screen. If you want the switch to retain the new values across a power cycle, you must perform a save.

Help for Double VLAN Tunneling Summary

Non-Configurable Data

• Slot/Port - The physical interface for which data is being displayed.
• Mode - This specifies the administrative mode via which Double VLAN Tagging can be enabled or disabled. The default value for this is Disabled.
• Customer ID - This is the 12 bit customer ID which will be used as the last 12 bits of the DVlan tag. The valid range for a customer Id is (0 to 4095). The default customer Id is 0 .
• EtherType - The two-byte hex EtherType to be used as the first 16 bits of the DVlan tag.
  • 802.1Q Tag - Commonly used tag representing 0x8100
  • vMAN Tag - Commonly used tag representing 0x88A8
  • Custom Tag - Configure the EtherType in any range from (0 to 65535)

Command Buttons

• Refresh - Refresh the data on the screen with the present state of the data in the switch.